Epson Stylus Photo 2100 - Page 167

EPSON Stylus PHOTO 2100/2200 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 167
Figure 4-103. Removing the PE Sensor Unit
6. Disconnect the Connector Cables, which are connected to the PE Sensor, from the
PE Sensor Connector and hook, and remove the PE Sensor Unit.
7. Release the PE Sensor Fixing Hook that secures the PE Sensor to the PE Sensor
Unit, and remove the PE Sensor.
Figure 4-104. Removing the PE Sensor
When reinstalling the PE Sensor Unit, secure it with three hooks.
Refer to Figure 4-103, "Removing the PE Sensor Unit".
Hooks
PE Sensor
Unit
Hook
Projection
1 1
Hook
2
3
When connecting the Connector to the PE Sensor, hitch the
Connector Cables on the hook.
Refer to Figure 4-104, "Removing the PE Sensor".
PE Sensor Fixing Hook
PE Sensor
Connector
Connector
Cable
Hook