Epson Stylus Photo 2100 - Page 173

EPSON Stylus PHOTO 2100/2200 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 173
8. Remove the Torsion Spring 7.13 that engages the DE Unit, ASF/Pump Motor and
Under Frame.
Figure 4-118. Removing the Torsion Spring 7.13
9. Remove the one screw 6) C.B.S 3×6 (9±1kgf.cm) and one screw 14) C.B.P 3×8
(6±1kgf.cm) that secure the DE Unit.
Figure 4-119. Screws That Secure the DE Unit
10. Slide the DE Unit rear side to the printer left side as seen from the printer rear, pull
off the DE Unit upper side to the front, and remove the DE Unit together with the
ASF/Pump Motor.
Figure 4-120. Removing the DE Unit
When reinstalling the Torsion Spring 7.13, bring the straight leg
tip into contact with the ASF/Pump Motor, and hitch the other leg
tip on the hole in the Under Frame.
Refer to Figure 4-118, "Removing the Torsion Spring 7.13".
Circuit Board
Torsion Spring 7.13
C.B.P 3×8
ASF/Pump Motor
Hole in Under
Frame
Rear left side
Front right side
C.B.P 3×8
C.B.S 3×6
Front right side
1
2
DE Unit