Epson Stylus Photo 2100 - Page 79

EPSON Stylus PHOTO 2100/2200 Revision B
TROUBLESHOOTING Troubleshooting 79
Table 3-3. "Phenomenon-Based Communication Error Check Points"
Occurrence Timing Phenomenon Detail
Faulty Part/
Part Name
Check Point Remedy
At power-on The printer does not operate at all. Panel FFC 1. Check that the Panel FFC is connected to the connector of the
Panel board correctly.
2. Check the Panel FFC for damage.
1. Connect the Panel FFC to the connector of the
Panel board correctly.
2. Change the Panel FFC for a new one.
Panel board 1. Check the Panel board for damage. 1. Change the Panel board for a new one.
Power supply
board
1. Check that the connector cable of the Power supply board is
connected to CN15 on the Main board.
2. Check that the blue-lined pin of the Power supply board
connector cable is inserted into the 1 pin side.
(Refer to the above photo.)
1. Connect the connector cable of the Power
supply board to CN15 on the Main board.
2. Connect the Power supply board connector
cable with the blue-lined side placed on the 1
pin side.
Panel board
Panel FFC
CN15
Blue line