EPSON Stylus PHOTO 2100/2200 Revision B
TROUBLESHOOTING Troubleshooting 80
At power-on The printer does not operate at all. Power supply
board
3. Check that the Fuse (F1) on the Power supply board is not blown.
4. Check the devices on the Power supply board for damage.
5. Check the connector cable of the Power supply board for damage.
3. Change the Fuse (F1) for a new one.
4. Change the Power supply board for a new one.
5. Change the Power supply board for a new one.
At operation Operation at power-on is normal,
but the error appears when the
print jog is sent to the printer.
Interface cable 1. Check that the Interface cable is connected between the PC and
printer.
2. Check the Interface cable for wire break.
1. Connect the Interface cable to the PC and
printer.
2. Change the Interface cable for a new one.
EPSON USB
driver
1. When USB is used, check that the EPSON USB driver has been
installed in the PC.
1. Install the EPSON USB driver.
Table 3-3. "Phenomenon-Based Communication Error Check Points"
Occurrence Timing Phenomenon Detail
Faulty Part/
Part Name
Check Point Remedy
Fuse (F1)
Connector cable
To Next Page
Loading...
