Epson Stylus Photo 2100 - Page 85

EPSON Stylus PHOTO 2100/2200 Revision B
TROUBLESHOOTING Troubleshooting 85
The Paper feed switch
was pressed at the
setting of the CD-R
tray.
(Only for Stylus
PHOTO 2100)
The CD-R tray is fed toward the
ASF but is ejected immediately.
CD-R tray 1. Check the HP detection position of the CD-R tray for paper dust
or foreign matter.
2. Check the Driven roller surface for contamination such as paper
dust and CD-R coating.
3. Check the HP detection position of the CD-R tray for
contamination or damage.
1. Remove paper dust and/or foreign matter from
the detection portion.
2. Pass plain paper of A3+ width from the ASF
several times to remove contamination.
3. Change the CD-R tray for a new one.
PW sensor 1. Check the PW sensor for contamination such as paper dust.
2. Compare the EEPROM 76<H> and BB<H> values and check that
they are not approximate to each other.
1. Clean the PW sensor surface.
2. Change the PW sensor for a new one.
Table 3-5. Phenomenon-Based Paper Out Error Check Points
Occurrence Timing Phenomenon Detail
Faulty Part/
Part Name
Check Point Remedy
CD-R tray
HP detection position
PW sensor
Carriage unit bottom