Epson Stylus Photo 2100 - Page 94

EPSON Stylus PHOTO 2100/2200 Revision B
TROUBLESHOOTING Troubleshooting 94
Table 3-15. Phenomenon-Based Cutter Position Error Check Points
Occurrence Timing Phenomenon Detail
Faulty Part/Part
Name
Check Point Remedy
At Cutter unit fitting
(At power-on)
At power-on, the Carriage
produces operating sound
instantaneously but the Paper
LED indicates Blink 2
immediately.
Cutter motor 1. Check that the Cutter motor connector cable is connected to CN2
on the Driver board correctly.
2. Check the Cutter motor for a failure.
3. Check the Cutter motor connector cable for damage.
* Above 1 to 3 assume that the Cutter is not in the right HP
position.
1. Connect the Cutter motor connector to CN2 on
the Driver board securely.
2. Change the Cutter motor for a new one.
3. Change the Cutter motor for a new one.
At roll paper feeding
by auto loading
After the roll paper is fed, the
Cutter produces operating noise.
Cutter HP sensor
(right)
1. Check the Cutter HP sensor (right) and the rail groove of the
Cutter for paper dust, foreign matter, etc.
2. Check that the connector cable of the Cutter HP sensor (right) is
connected securely.
3. Check the Cutter HP sensor (right) for damage.
1. Remove the paper dust, foreign matter, etc.
from the Cutter HP sensor (right) and the rail
groove of the Cutter.
2. Connect the connector cable of the Cutter HP
sensor (right) to CN4 on the Driver board
securely.
3. Change the Cutter HP sensor (right) for a new
one.
Cutter motor
CN2
Driver board
Cutter HP sensor (right)
CN4