Epson Stylus Photo 2100 - Page 97

EPSON Stylus PHOTO 2100/2200 Revision B
TROUBLESHOOTING Troubleshooting 97
At power-on The power-on sequence is
executed but Fatal error is
displayed.
PF drive system 1. Check B9<H> of the EEPROM to confirm that 79 is at 6C<H>. 1. If the value is as in Check point 2, change the
PF motor for a new one.
At power-on, the PF motor does
not operate at all.
PF motor 1. Check that the PF motor connector cable is connected to CN16
on the Main board correctly.
2. Using a tester, check that the resistance of the PF motor is
23.0Ω ± 25%.
3. Check the PF motor connector cable for damage.
1. Connect the PF motor connector cable to
CN16 on the Main board correctly.
2. If the resistance value is abnormal, change the
PF motor for a new one.
3. Change the PF motor for a new one.
Table 3-17. Phenomenon-Based Fatal Error Check Points
Occurrence Timing Phenomenon Detail
Faulty Part/Part
Name
Check Point Remedy
PF motor