34
5. Pull up the ink cartridge clamp. The cartridge rises up from its holder.
Don’t open the clamp or
remove a cartridge except
to replace it with a new
one. Once you remove a
cartridge, you can’t reuse
it, even if it contains ink.
6. Lift the cartridge out of the printer and
dispose of it carefully.
If ink gets on your hands, wash them thoroughly with soap
and water. If ink gets into your eyes, flush them immediately
with water.
7. Lower the new ink cartridge into its
holder with the label facing up and
toward the back of the printer.
8. Press down the ink cartridge clamp until
it locks in place.
9. If you need to replace the other ink
cartridge, repeat steps 5 through 8 before
going on to step 10.
10. Press the
E load/eject button and close the printer cover.
The printer moves the print head and begins charging the ink delivery system.
The
P power light flashes and the printer makes various sounds.
Charging takes about one minute. When it’s finished, the
P power light stops
flashing and stays on.
Never turn off the printer while the
P
power light is flashing,
unless the printer hasn’t moved or made noise for more than
5 minutes.
basics.book Page 34 Monday, February 22, 1999 9:31 AM
To Next Page
Loading...
