EPSON Stylus Photo 750 Revision A
Adjustment Adjustment 79
6. From this thickness with which the thickness gauge stars moving
with the carriage, move the gear of the “Bush, Parallel, Adjustment
one notch forward you. (Gap will be narrowed)
At this time, make sure that the thickness gauge does not move.
Figure 5-2. Paper Gap Adjustment
7. Perform the same procedures above (from 1 to 6) to the “Bush,
Parallel, Adjustment, Left”.
† Check the Gap
After completing the adjustment to “Bush, Parallel, Adjustment,
Left”, check the paper gap at the right side one more time.
† Fixing “Bush, Parallel, Adjustment, Right/Left”
After completing the paper gap adjustment, fix the “Bush, Parallel,
Adjustment, Left/ Right” by screws.
Position M ark
Forward
(G ap: W ider)
Backward
(G ap: N arrow er)
Side Fram e
"BUSH, PARALLEL ADJUST, RIGHT"
"LEVER, PG"
To Next Page
Loading...
