Epson Stylus Photo 925 - Page 101

EPSON Stylus Photo 925 Revision A
Disassembly and Assembly Disassembly 101
6. Remove the five screws (C.B.S SCREW, 3x4, F/ZN and C.B.S SCREW, 3x6, F/
ZN) securing the Cutter Unit.
Figure 4-58. Removing the Cutter Unit (1)
7. Move the CR Unit to the left end, and remove the Cutter Unit in the numerical order as
shown below.
Figure 4-59. Removing the Cutter Unit (2)
C.B.S SCREW, 3x4, F/ZN
C.B.S SCREW, 3x6, F/ZN
T Connect the Cutter Motor Connector Cable and CT Sensor
Connector Cable to the connectors (CN17 and CN15) on the
Main Board securely.
T Tightening torque for screws
• Two screws securing the Cutter Cover Bottom:
C.B.S SCREW, 3x6, F/ZN : 5 ~ 7kgf.cm
• Six screws securing the Cutter Unit:
C.B.S SCREW, 3x6, F/ZN : 8 ~ 10kgf.cm
C.B.S SCREW, 3x4, F/ZN : 8 ~ 10kgf.cm
A D J U S T M E N T
R E Q U I R E D
T Once the gear shaft which transmits the driving force from the
PF Motor to the paper eject roller (in the cutter mechanism) has
been removed or it has been replaced with a new one, apply an
appropriate amount of grease G-26 to the specified points.
(Refer to Figure 6-12. “Lubrication point 11” in Chapter 6.)
T Once the Cutter Unit has been removed, make the following
adjustments:
1. Cutter position adjustment
2. Printing on A4-size noramal paper
Cutter Unit
2
1