EPSON Stylus Photo 925 Revision A
Disassembly and Assembly Disassembly 103
6. Remove the three screws (C.P SCREW, 3x6, F/ZN and C.P SCREW, 2.5x6 F/ZN)
securing the Main Board to the Shield Plate.
Figure 4-62. Removing the Main Board (1)
7. Disconnect the power cable from the Main Board, remove the 9 screws (C.B.S.
SCREW, 3x6, F/ZN and C.B.S-TITE SCREW, 3x6, F/ZN) securing the Main
Board to the Shield Plate, and remove the Main Board.
Figure 4-63. Removing the Main Board (2)
8. Remove the four screws (C.B.S. SCREW, 3x6, F/ZN) securing the Power Supply
Board to the Shield Plate, and remove the Power Supply Board.
Figure 4-64. Removing the Power Supply Board
C.P SCREW, 3x6, F/ZN
C.P SCREW, 2.5x6, F/ZN
C.B.S SCREW, 3x6, F/ZN
C.B.S-TITE SCREW, 3x6, F/ZN
Power Cable
T When installing the Main Board and Power Supply Board,
secure the Cover Shield Plate with two screws (C.B.S-TITE
SCREW, 3x6, F/ZN).
Figure 4-65. Installing the Cover Shield Plate
C.B.S SCREW, 3x6, F/ZN
Cover Shield Plate
To Next Page
Loading...
