Epson Stylus Photo 925 - Page 114

EPSON Stylus Photo 925 Revision A
Disassembly and Assembly Disassembly 114
T Install the Paper Guide Top on the Main Frame by the
procedure described below:
1. Set the torsion spring on the hook on the Paper Guide Top.
Figure 4-88. Preparation for installing the Paper Guide Top
Hook
Torsion Spring
2. Install the Paper Guide Top on the Main Frame by following
the steps as shown below with arrows, and release the torsion
spring from the hook. Make certain that the projection of the
Paper Guide Top is fit in the cut hole in the Main Frame.
(For installation, insert an OHP sheet the same way as for
removal.)
Figure 4-89. Installing the Paper Guide Top
Cut holes
OHP sheet
Projections
2
1