Epson Stylus Photo 925 - Page 140

EPSON Stylus Photo 925 Revision A
Maintenance Overview 140
Table 6-2.Lubrication Point
NO. Lubrication Type/Point Remarks
1 <Lubrication Point>
• Part of the Driven Pulley Holder which comes in
contact with the main frame
See Figure 6-2. "Lubrication point 1".
<Lubrication Type>
•G-26
<Lubrication Amount>
• φ1mm x 1mm x 4 points
• Apply with a
dropping pipet.
2 <Lubrication Point>
• Inside the bore of the CR shaft of the CR Unit
See Figure 6-3. "Lubrication point 2".
<Lubrication Type>
•G-56
<Lubrication Amount>
• Apply 12.5 ~ 37.5 mg of lubricant to 8 points.
• Lubricate with a
dropping pipet.
• Do not attach the
grease to any other
portion of the CR
unit.
• While turning the CR
Guide Shaft, apply
grease to every part of
the peripheral surface
of the CR Guide
Shaft.
• After lubrication,
make sure that the CR
unit smoothly.
3 <Lubrication Point>
Part of the ASF Hopper which comes in contact with the
cam of the LD Roller (left side)
See Figure 6-4. "Lubrication point 3".
<Lubrication Type>
•G-26
<Lubrication Amount>
• φ1mm x 2mm
• Lubricate with a
dropping pipet.
• Apply grease
properly to the
surfaces of the ASF
Hopper and LD
Roller Cam which
come in contact with
each other.
4 <Lubrication Point>
Part of the gear (spur gear 35.2) of the clutch mechanism
which come in contact with the LD Holder
See Figure 6-5. "Lubrication point 4".
<Lubrication Type>
•G-26
<Lubrication Amount>
• φ1mm x 2 points
• Apply grease
properly to the
surfaces of the spur
gear 35.2 and LD
Holder which come in
contact with each
other.
5 <Lubrication Point>
• Shaft for spur gear 23.2 on the ASF frame
See Figure 6-6. "Lubrication point 5".
<Lubrication Type>
•G-26
<Lubrication Amount>
• φ1mm x 2mm
• Lubricate with a
dropping pipet.
6 <Lubrication Point>
• Part of the ASF Hopper which come in contact with
the ASF frame
See Figure 6-7. "Lubrication point 6".
<Lubrication Type>
•G-26
<Lubrication Amount>
• 5mm x 2 points
• Lubricate with a
dropping pipet.
• After applying grease,
operate the ASF
Hopper so that the
grease is spread to
every part.
7 <Lubrication Point>
• Part of the front frame where the CR Unit (CR Slider)
operates
See Figure 6-8. "Lubrication point 7".
<Lubrication Type>
•G-26
<Lubrication Amount>
• φ1mm x 200mm
• Use the lubrication
tool dedicated for the
front frame.
• Apply grease in the
left-to-right direction.
Table 6-2.Lubrication Point (continued)
NO. Lubrication Type/Point Remarks