Epson Stylus Photo 925 - Aligning the Print Head

EPSON Stylus Photo 925 Revision A
Disassembly and Assembly Disassembly 81
4.2.2 Panel Unit removal
1. Remove the Housing from the printer. (Refer to 4.2.1 “Housing removal”)
2. Remove the four screws (C.B.P-TITE SCREW, 3x8, F/ZN) securing the Panel
Unit to the Housing and remove the Panel Unit.
Figure 4-8. Removing the Panel Unit
3. Disconnect the Panel FFC from the Panel Board.
C.B.P-TITE SCREW, 3x8, F/ZN
T The buttons will come off when the Panel Unit is removed from
the Housing. In installation, locate the buttons as shown below.
Figure 4-9. Installing the Buttons
T Tightening torque for screws
• Four screws securing the Panel Unit:
C.B.P-TITE SCREW, 3x8, F/ZN: 5 ~ 7kgf.cm