EPSON Stylus Photo 925 Revision A
Disassembly and Assembly Disassembly 84
3. Remove the four screws (C.B.S SCREW, 3x6, F/ZN and C.B.S SCREW, 3x4, F/
ZN) securing the Housing Lower Cover Right Front.
Figure 4-14. Removing the Housing Lower Cover Right Front (1)
4. Disengage the projection of the Shield Plate by using a screwdriver, and remove
the Housing Lower Cover Right Front.
Figure 4-15. Removing the Housing Lower Cover Right Front (2)
C.B.S SCREW, 3x6, F/ZN
C.B.S SCREW, 3x4, F/ZN
T Install the Housing Lower Cover Right Front so that the
projection as shown below is positioned inside.
Figure 4-16. Installing the Housing Lower Cover Right Rear
T Tightening torque for screws
• Eight screws securing the Housing Lower Cover Right Rear/Front
C.B.P-TITE SCREW, 3x8, F/ZN : 5 ~ 7kgf.cm
C.B.S SCREW, 3x6, F/ZN : 5 ~ 7kgf.cm
C.B.S SCREW, 3x4, F/ZN : 5 ~ 7kgf.cm
To Next Page
Loading...
