Epson Stylus Photo 925 - Printing Your Selected Photos

Printing Your Selected Photos 27
Printing Your Selected Photos
Once you’ve selected your photos, follow these steps to start printing:
1. Load your paper in the printer, as described on page 11 (for individual sheets) or page 13
(for roll paper).
Note: If you’re not sure which type of paper to use, see “Choosing the Paper for
Your Project” on page 8.
2. Enter the Paper Type menu. Highlight the type of paper you’ve loaded, then press
Select. If you’re not sure about the paper type, see the table on page 29.
Note: It’s important to select the correct Paper Type setting for the
paper you’re using, or the print quality may not be what you expect.
3. Enter the Paper Size menu, then select the size of paper you’ve loaded.
For example, if you’re printing with roll paper, select
4" Roll.
4. In the
Layout menu, select one of the following (see page 30 for a list of the resulting
photo sizes for each layout):
Prints one photo per sheet, borderless; fits the photo lengthwise on the paper.
Roll paper only. Prints one photo, borderless; fits the photo across the paper.
Prints one photo per sheet, with borders around the edges.
Prints two photos per sheet.
Prints three photos per sheet.
Prints four photos per sheet.
Prints nine photos per sheet.
Prints 20 photos per sheet; the photo number and date are also printed with each
photo. (Good for printing larger-size index prints.)
Roll paper only. Prints one photo per sheet, borderless; the long edge of each photo
prints along the length of the paper, and the photo is cropped to create a
“panoramic” look.
Prints six of the same photo per sheet, in various sizes.
Pbasics.book Page 27 Wednesday, April 23, 2003 4:30 PM