EPSON Stylus Photo R1800/R2400 Revision B
Disassembly And Assembly Disassembly 104
5. Release the CSIC Board Cover from the four Tabs with a flat-blade
screwdriver, and remove the CSIC Board Cover from the Carriage Unit.
Figure 4-79. Removing the CSIC Board Cover
6. Disconnect the Sensor FFC from the CSIC Board Connector. See Step 26
in Section 4.2.6.4 on page 101.
7. Hold the CSIC Board Spacer with your fingers and remove upwards.
Figure 4-80. Removing the CSIC Board Spacer
8. Push up the CSIC Board with a flat-blade screwdriver from the notch on
the right side of the Carriage Unit, and remove the CSIC Board from the
Carriage Unit.
Figure 4-81. Removing CSIC Board
CSIC Board Cover
Tabs
CSIC Board Spacer
The CSIC Board Spacer must be installed at the position
indicated in the figure below.
Figure 4-82. Reinstalling the CSIC Board Spacer
CSIC Board
CSIC Board
CSIC Board Spacer
To Next Page
Loading...
