Epson Stylus Photo R1800 - Reassembling the Right CD-R Release Lever Sub Assy

EPSON Stylus Photo R1800/R2400 Revision B
Disassembly And Assembly Disassembly 107
5. To prevent parts from dropping, refit the shaft on the Right CD-R Release
Base into the CD-R Release Lever.
6. Press the Guide Pin that secures the Right CD-R Release Lever Sub Assy
with tweezers, and remove it upwards from the Main Frame.
Figure 4-88. Removing the Right CD-R Release Lever Sub Assy (3)
Tab
Guide Pin
 Make sure that the Right CD-R Release Lever Sub Assy
is correctly assembled as shown in the figure below.
Figure 4-89. Reassembling the Right CD-R Release Lever
Sub Assy
 Align the Shaft and Bushing.
Figure 4-90. Reinstalling the Right CD-R Release Lever Sub
Assy
 Align the positioning hole of the Right CD-R Release
Lever Sub Assy with the Tab on the Main Frame. See
Figure 4-88.