Epson Stylus Photo R1800 - Removing the Spur Gear 68; Removing the Left CD-R Release Lever Sub Assy; Reinstalling the Left CD-R Release Lever Sub Assy

EPSON Stylus Photo R1800/R2400 Revision B
Disassembly And Assembly Disassembly 108
7. Remove Spur Gear 68 from the Paper EJ Roller Shaft.
Figure 4-91. Removing the Spur Gear 68
8. Remove the C.B.P. M3 x 6 screw that secures the Left CD-R Release
Lever Sub Assy.
9. Press the small Tab of the Left CD-R Release Lever Sub Assy with a flat-
blade screwdriver, and remove the Left CD-R Release Lever Sub Assy
upwards from the Main Frame.
Figure 4-92. Removing the Left CD-R Release Lever Sub Assy
Spur Gear 68
Tabs
Small Tab 9) C.B.P. 3x6
(6±1 kgf.cm)
 Make sure that the Left CD-R Release Lever Sub Assy is
correctly assembled as shown in the figure below.
Figure 4-93. Reinstalling the Left CD-R Release Lever Sub
Assy (1)
 Align the Shaft and Bushing.
Figure 4-94. Removing the Left CD-R Release Lever Sub
Assy (2)
 Align the two Tabs on the Left CD-R Release Lever Sub
Assy with the positioning holes on the Main Frame. See
Figure 4-92.