Epson Stylus Photo R1800 - Screws that Secure the Ink System Unit; Removing the Right Support Frame; Installing the Support Frame

EPSON Stylus Photo R1800/R2400 Revision B
Disassembly And Assembly Disassembly 110
6. Remove the two C.B.S. M3 x 6 screws that secure the Ink System Unit.
Figure 4-98. Screws that Secure the Ink System Unit
7. Remove the two C.B.S. M3 x 6 screws that secure the Right Support
Frame, and remove the Right Support Frame from the Main Frame.
Figure 4-99. Removing the Right Support Frame
Tighten the screws in the order shown in Figure 4-98.
2
Rear
1
Front
2) C.B.S. 3x6
(8±1 kgf.cm)
 Align the positioning holes on the Right Support Frame
with the Guide Pins on the Main Frame.
Figure 4-100. Installing the Support Frame (Right)
 Tighten the screws in the order shown in Figure 4-99.
Right Support
Frame
2
Upper
surface
2) C.B.S. 3x6
(8±1 kgf.cm)
1
2) C.B.S. 3x6
(8±1 kgf.cm)
Positioning Holes and
Guide Pins