Epson Stylus Photo R1800 - Writing of Color ID

EPSON Stylus Photo R1800/R2400 Revision B
Adjustment Adjustment 156
13. Click [Next], and write the Color ID to the printer.
Figure 5-38. Writing of Color ID
C A U T I O N
 Be sure to start the measurement from the top side of the
chart.
 Take more than 10 seconds to measure one row.
 Slide the calibrator at a constant speed.
 During color measurement, do not allow the Calibrator to
rub against unmeasured patches on the chart.
 Prevent the ruler and Calibrator from coming off the
chart sheet during color measurement. Doing so will
cause incorrect color measurement.
 During color measurement, measure only the patches on
the chart sheet. Do not measure other parts such as the
USB ID text string.
 When there is an error possibility in measuring color, a
warning mark ( ) appears at the patch in question. In
such case, make sure to measure the row that includes
the patch with a warning mark again.
 If the number of scanned patches does not match the
number of patches on a single row, the cursor stops at
that row, the error mark ( ) appears on all of the
patches on that row, and the following error message is
displayed:
• "Color measuring by Eye-One calibrator has failed.
Measure colors of the failed row again."
C H E C K
P O I N T
It takes about three minutes to write the Color ID to the
printer.
Figure 5-39. Writing of Color ID in Progress