Epson Stylus Photo R1800 - List of Error Messages

EPSON Stylus Photo R1800/R2400 Revision B
Adjustment Adjustment 163
5. When the following screen is displayed, click [End], and turn the
printer OFF then back ON again to end the adjustment. This
action reflects the color measurement values on the printer.
Figure 5-55. END
5.2.4.3 Error Messages
The following table lists the error and warning messages that are generated by
the Colorimetric Calibration Tool
Table 5-7. List of Error Messages
Error Message
Communication Error Communication error. Check the connection status with
the printer.
Timeout Time-out error. Check the connection status with the
printer.
Printer Driver not
installed
The printer driver is not installed. Install the printer driver.
Printer not connected The printer is not connected. Connect the printer and
press [Retry] to check the printer connection again.
Ink Cartridge Low‘ The remaining amount of the following ink(s) is low.
Replace the corresponding ink cartridge(s) with a new
one.
XXXXX, XXXXX
When installing a new cartridge(s), make sure to shake it
(them) at least four times. A cleaning cycle will
automatically start when a new cartridge(s) is installed. To
stop the process, click [End].
Cleaning error Error occurred while running the cleaning cycle. Check
the printer status.
Automatic nozzle
check failure
The automatic nozzle check has failed. There may be a
problem with the print head.
Automatic nozzle
check error
Error occurred while performing nozzle check. Check the
printer status.
Ink mark sensor error The automatic nozzle check has finished unsuccessfully.
Click OK to start a nozzle check manually.
Color ID write error Writing Color ID has failed. Check the printer status.
File save error Saving the file has failed. Check if the disc has enough
space, or if the folder is writable.
File open error Reading the data file has failed. Check the date and size
of the data file.
File format error The file format is incorrect. Check if the correct file is
selected.
Color ID parameter
error
The parameters of the Color ID value are invalid.