Epson Stylus Photo R1800 - Indicator Display in Normal Mode; Printer Condition and LED Status

EPSON Stylus Photo R1800/R2400 Revision B
Stylus Photo R2400 Overview 200
8.1.2 Indicator Display in Normal Mode
Note: • "–" : Don't care
• Blink : 0.5sec on + 0.5sec off repetition
• Blink 2 : 0.2sec on + 0.2sec + 0.2sec on + 0.4sec off repetition
• Fast Blink : 0.1sec on + 0.1sec off repetition
• Blink alternately 1 : 0.5sec on + 0.5sec off repetition
• Blink alternately 2 : 0.5sec off + 0.5sec on repetition
Note"*1": When reset occurs (when the printer receives IEEE1284.4 "rs" command, or when printing of a
status sheet is finished), the LEDs light for 0.2 second to indicate that the printer accepted the
command.
"*2":The ink LED that corresponds to each cartridge row (A,BC,D,E,F,G, and H) is displayed
independently.
When facing front of printer, insertion locations (rows) of ink cartridges are taken as
A,B,C,D,E,F,G, and H from the left. These rows correspond to LED1, LED2, LED3, LED4, LED5,
LED6, LED7, and LED8, respectively.
Table 8-1. Printer Condition and LED Status
Printer status Error status
Indicators
Power Paper Ink Priority
Idle – On – – 20
Data processing – Blink – – 19
Ink sequence processing – Blink – – 17
Ink cartridge change mode – Blink – – 16
Ink low (warning) – – – Blink
*2
15
Tear off status 11h – – – 14
Cover Open (Tray) Error 2Bh Fast Blink Blink 2 – –
Paper mismatch Error 0Ch – Fast Blink – 12
Paper Out 06h – On – 11
Ink end 05h – – On
*2
10
No Ink cartridge or
Ink cartridge error
05h – – On
*2
9
Paper Jam Error 04h – Blink – 8
Reset input
*1
–OnOnOn–
Fatal error 00h Off Fast Blink Fast Blink 4
Maintenance request
10h
Off Blink
alternately 1
Blink
alternately 2
2
Power off – Fast Blink Off Off 1