Epson Stylus Photo R1800 - Adjusting the Print Position

EPSON Stylus Photo R1800/R2400 Revision B
Disassembly And Assembly Disassembly 74
4.2.1 Removing the Housings
4.2.1.1 Rear Housing
1. Remove the four C.B.P. M3 x 10 screws and the C.B.S. M3 x 6 screw that
secure the Rear Housing, and remove it from the printer.
Figure 4-2. Removing the Rear Housing
4.2.1.2 Side Housing
1. Remove the Rear Housing. See Section 4.2.1.1 on page 74.
2. Insert a flat-blade screwdriver into the notch on the side of the Lower
Housing, and lift it in the direction of the arrow to remove the Left Side
Housing releasing the two tabs.
Remove the Right Side Housing in the same way.
Figure 4-3. Removing the Side Housings
Rear Housing
1) C.B.P. 3x10
(6±1 kgf.cm)
2) C.B.S. 3x6
(6±1 kgf.cm)
Side Housing