Epson Stylus Photo R1800 - Removing the Boards; Board Assy; Screws that Secure the Board Assy; Removing the Board Assy

EPSON Stylus Photo R1800/R2400 Revision B
Disassembly And Assembly Disassembly 87
4.2.5 Removing the Boards
4.2.5.1 Board Assy
1. Remove the Rear Housing. See Section 4.2.1.1 on page 74.
2. Remove the four C.B.S. M3 x 6 screws and two C.B.S. (P2) M3 x 10
screws that secure the Board Assy.
Figure 4-28. Screws that Secure the Board Assy
3. Disconnect all the FFCs and Connector Cables connected to the Board
Assy in order from the front, and draw out the Board Assy from the Printer
taking care to avoid interference between the Manual Paper Guide and the
Ground Plates on the Board Assy.
 CN5 : Relay FFC
 CN8 : LED FFC
 CN9 : Sensor FFC
 CN10 : Sensor FFC
 CN11 : Head FFC
 CN12 : Head FFC
 CN13 : Head FFC
 CN14 : Head FFC
 CN16 : PF Motor Connector Cable
 CN17 : Relay Connector Cable (for Pump Motor)
 CN18 : APG Motor Connector Cable
 CN19 : Relay Connector Cable (for CR Motor)
Figure 4-29. Removing the Board Assy
Tighten the screws in the order shown in Figure 4-28.
C A U T I O N
When performing the following procedure, prevent the FFC
and Connector Cables from being scratched.
Board Assy
1
2
3
4
5
6
3) C.B.S. (P2) 3x10
(6±1 kgf.cm)
2) C.B.S. 3x6
(8±1 kgf.cm)
FFCs and Connectors
Point of
Interference
Board Assy
Manual Paper
Guide
Grounding Plate