Epson Stylus Photo R1800 - Quality Problems

EPSON Stylus Photo R1800/R2400 Revision B
Disassembly And Assembly Disassembly 96
7. Remove the foot of Left PG Torsion Spring from Tab A, and remove the
coil section from Tab B to remove Left PG Torsion Spring from the Main
Frame.
Figure 4-51. Removing Left PG Torsion Spring
8. Remove the foot of Right PG Torsion Spring from Tab A, and remove the
coil section from Tab B to remove Right PG Torsion Spring from the Main
Frame.
Figure 4-52. Removing Right PG Torsion Spring
9. Remove CR Shaft Mounting Plate Fixed Spring from the Tab and Notch on
the Main Frame, and draw out the spring in the direction of the arrow.
Figure 4-54. Removing CR Shaft Mounting Plate Fixed Spring
Left PG Torsion Spring
Tab A
Tab B
Right PG Torsion Spring
Tab A
Tab B
Place the feet of Left PG Torsion Spring and Right PG
Torsion Spring on the Carriage Shaft.
Figure 4-53. Reinstalling PG Torsion Springs
Insert the foot of CR Shaft Mounting Plate Fixed Spring into
the notch on the Main Frame (rear side). See Figure 4-54.
Foot
Left Side
Foot
Right Side
Tab
CR Shaft Mounting Plate Fixed Spring
Notch
Notch (rear side)