Epson Stylus Photo R320 - 2.3.3 Removing Housing, Upper

EPSON Stylus Photo R320 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 40
2.3.3 Removing Housing, Upper
 External View
Figure 2-4. Removing "Housing, Upper"
 Parts/Units which should be removed before removing "Housing, Upper"
Paper Support Assy./Preview Monitor Unit
 Procedure for Removing
1. Release the dowels(x2) of "Printer Cover". Then remove the "Printer Cover"
from "Housing Upper".
2. Remove the screws (x4) which secure "Housing, Upper".
3. Release "Carriage Lock" with the tweezers or alike and then move "Carriage
Unit" toward the centre.
4. Release the hooks (x4) which secure "Housing, Upper" and then lift up
"Housing, Upper".
5. Detach "Panel FFC" from the connector of "Panel Board" and then remove
"Housing, Upper".
Printer Cover
Dowels
Housing, Upper
C.B.P 3x8 (4-6kgf•cm)
1
2
4
3
Carriage Unit
Carriage Lock
Hooks Hooks
Connector
Panel FFC
 Tighten the screws in the order as shown in the figure.
 Make sure to put the dowels (x2) of "Housing, Upper" into the
attaching holes (x2) on "Printer Cover".
Figure 2-5. Reinstalling "Printer Cover"
Dowels
Printer Cover
Attaching Holes