Epson Stylus Photo R320 - 2.3.4 Removing Housing, Middle

EPSON Stylus Photo R320 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 41
2.3.4 Removing Housing, Middle
 External View
Figure 2-6. Removing "Housing, Middle"
 Parts/Units which should be removed before removing "Housing, Middle"
Paper Support Assy./Preview Monitor Unit/Housing, Upper
 Procedure for Removing
1. Pull out "Panel FFC" from "Ferrite Core".
2. Take off the two-sided tape which fixing the "Panel FFC" from "Housing
Middle".
3. Remove the screw which secures "Cover, Ink Tube", release the hook and
then remove "Cover, Ink Tube".
4. Remove the screws (x4) which secure "Housing, Middle".
5. Lay down the printer backward, put a flat-blade screwdriver or alike into the
slot located on the bottom surface of "Housing, Lower" and then release the
hooks (x2) which secure "Housing, Middle".
6. Lift "Housing, Middle" upward and remove it.
Fixed spring, Core
C.B.P 3x8
(4-6kgf•cm)
Panel FFC
Two-sided
Tape
Ferrite Core
C.B.S 3x8 (6-8kgf•cm)Housing, Middle
C.B.P 2.5x8
(3-5kgf•cm)
Hook Cover, Ink Tube
21
C.B.P 3x8
(4-6kgf•cm)
C.B.S 3x10
(4-6kgf•cm)
Slots and Hook
Housing, Lower
C A U T I O N
Do not damage the hooks of "Housing, Middle" with the flat-blade
screwdriver or alike.
 Through the "Monitor FFC" into the hole on "Housing Middle".
Figure 2-7. Reinstalling "Housing, Middle"
Hole
Monitor FFC