Epson Stylus Photo R320 - 2.3.12 Removing APG Assy.

EPSON Stylus Photo R320 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 57
2.3.12 Removing APG Assy.
 External View
Figure 2-32. Removing "APG Assy."
 Parts/Units which should be removed before removing "APG Assy."
Paper Support Assy./Preview Monitor Unit/Housing, Upper/Housing, Middle
 Procedure for Removing
1. Disconnect the connector cable of "PG Motor" from CN7 of "Main Board".
2. Release the connector cables of "PF Motor" and "PG Motor" from the
following points.
 Take off the Acetate Tape(x2).
 Remove from the hook on "ASF Assy".
 Cut the tie wrap
 Remove the screw (Screw, Frame, Main) (x3) which secure the connector
cable.
3. Remove the screw which secures "APG Assy.". Then, remove "APG Assy.".
ASF Assy. Connector Cable
Acetate Tape
Tie wrap
Screw, Frame, Main (5-7kgf.cm)
3 2 1
CN7
Acetate Tape
Hook
APG Assy.
C.B.S 3x6 (6-8kgf•cm)