EPSON Stylus Photo R320 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 72
2.3.18 Removing CDR Guide Assy.
External View
Figure 2-52. Removing "CDR Guide Assy." (1)
Figure 2-53. Removing "CDR Guide Assy." (2)
Parts/Units which should be removed before removing "CDR Guide Assy."
Paper Support Assy./Preview Monitor Unit/Housing, Upper/Housing, Middle/
Main Board Unit/ASF Assy./Holder, Shaft Assy./APG Assy./
Print Head/Carriage Unit/Printer Mechanism
Procedure for Removing
1. Take off the acetate tape and release the connector cable of "Star Wheel/ CDR
Sensor".
2. Remove the screws (x2) which secure "Support Plate, Frame, Main". Then,
remove "Support Plate, Frame, Main".
3. Remove the screws (x3) which secure "CDR Guide Assy.".
4. Remove the flat washer which secure "Link, CDR Left (Right)" with the
tweezers. Then, Remove "Link, CDR Left (Right)" from "CDR Guide Assy.".
5. Release the ribs (x7) which secure "CDR Guide Assy.", then remove "CDR
Guide Assy." through the right edge.
6. Remove the screws (x2) which secure "CDR Guide, Lower".
7. Slide "CDR Guide, Lower" and then release the hooks (x7). After that,
remove "CDR Guide, Lower".
Flat Washer
1
3
C.B.S 3x6 (6-8kgf•cm)
Ribs
Link, CDR Left
CDR Guide Assy.
2
C.B.S 3x6 (6-8kgf•cm)Link, CDR Right
Ribs
Ribs
Flat Washer
Acetate Tape
C.B.S 3x6 (7-9kgf•cm)
1
2
Support Plate, Frame, Main
Connector Cable
C.B.P 3x6 (5-7kgf•cm)
Hooks
1
2
Hooks
CDR Guide, Lower
To Next Page
Loading...
