EPSON Stylus Photo R800 Revision A
TROUBLESHOOTING Overview 53
Table 3-11. Phenomenon-Based Cutter Jam Error Check Points
Occurrence
Timing
Phenomenon Detail
Faulty Part/
Part Name
Check Point Remedy
At roll paper feeding When the paper roll is fed,
the Cutter produces
operating noise.
Cutter Unit 1. Check the rail groove of the Cutter for paper dust, foreign
matter, etc.
1. Remove the paper dust, foreign matter,
etc. from the rail groove of the Cutter.
After end of printing The roll paper is not cut after
end of printing.
Cutter Motor 1. Check that the Connector cable of the Cutter Motor is
connected to the Relay Board Connector (CN2).
1. Connect the Connector cable of the
Cutter Motor to the Relay Board
Connector.
2. Check the Cutter Motor or Connector cable for damage. 2. Change the Cutter Motor for a new one.
At roll paper
cutting
The roll paper is cut only
halfway.
Cutter Unit 1. Check that the paper used is not other than the EPSON
special media.
1. Use the EPSON special media.
2. Check the Cutter for damage. 2. Change the Cutter Unit for a new one.
Rail Groove
CN2
Cutter Motor
Download Service Manual And Resetter Printer at http://printer1.blogspot.com
To Next Page
Loading...
