Epson Stylus Photo R800 - Page 53

EPSON Stylus Photo R800 Revision A
TROUBLESHOOTING Overview 54
Table 3-12. Phenomenon-Based Cutter Position Error Check Points
Occurrence
Timing
Phenomenon Detail
Faulty Part/
Part Name
Check Point Remedy
At Cutter unit fitting
(At power-on)
At power-on, an error is
displayed on the Paper LED
and EPW3.
Cutter Motor 1. Check that the Connector cable of the Cutter Motor is
connected to the Relay Board Connector (CN2).
(When the Cutter position is other than the HP)
1. Connect the Connector cable of the Cutter
Motor to the Relay Board Connector.
2. Check the Cutter Motor or Connector cable for damage.
(When the Cutter position is other than the HP)
2. Change the Cutter Motor for a new one.
The Cutter produces
operating noise.
Cutter HP
Sensor (right)
1. Check the Cutter HP Sensor (right) or the rail groove of the
Cutter for paper dust, foreign matter, etc.
1. Remove the paper dust, foreign matter,
etc. from the Cutter HP Sensor (right) or
the rail groove of the Cutter.
2. Check that the Connector cable of the Cutter HP Sensor
(right) is connected to the Cuter HP Sensor (right) and
Relay Board Connector (CN4).
2. Connect the Connector cable of the Cutter
HP Sensor (right) to the Cuter HP Sensor
(right) and Relay Board Connector.
3. Check the Cutter HP Sensor (right) for damage. 3. Change the Cutter HP Sensor (right) for a
new one.
CN2
Cutter Motor
Cutter HP Sensor (right)
CN4
Download Service Manual And Resetter Printer at http://printer1.blogspot.com