EPSON Stylus Photo RX585/RX595/RX610 Revision B
Troubleshooting Troubleshooting When There is Error Display 42
3.2.2 Warning List
Paper Empty Error Paper out. Load paper and press the Start button. There is no paper in the sheet feeder.
Press the start button to feed paper
correctly.
Multi-page Feed Error
Multi-page feed error. Remove and reload the paper, then
press the Start button.
Multi-page feed error has occurred.
Re-set paper and press the start button to
feed paper correctly.
Scanner Open Error Close the scanner unit.
The scanner unit is opened during stand-alone printing,
copying, or printing from an external device.
Close the scanner unit.
Table 3-1. Error List (continued)
Error Name Displayed Message Occurrence Condition Recovery Procedure
Table 3-2. Warning List
Warning Name Displayed Message Occurrence Condition Recovery Procedure
Waste fluid is near end
Waste ink pad in the printer is saturated. Contact your dealer to
replace it.
The waste ink pads have already absorbed waste ink nearly
to its full capacity.
Replace the waste ink pads.
See “6.1.1 Maintenance Error”
(p.116)
Set the CD-R/DVD tray
(Set correctly)
The CD/DVD tray is set incorrectly. Set the CD/DVD tray
correctly, then press the Start button.
At start of printing, the printer has not recognized the CD-R/
DVD tray correctly.
Set the CD-R/DVD tray correctly, and
press the Start button.
CD/DVD guide warning
(Open error)
The front tray is in the CD/DVD position. Raise the tray lever to
set the front tray to the paper position.
When printing data is not for printing on CD/DVD, the tray
is in the CD/DVD printing position. Or the tray is in the CD/
DVD printing position when the printer is started.
Raise the lever to change the printing
position to the lower position.
CD/DVD guide warning
(Close error)
The front tray is in the wrong position. Push down the tray lever
to set the front tray to the CD/DVD position.
When printing data is for printing on a CD/DVD, the CD-R/
DVD tray is not recognized correctly. .
Lower the lever to change the print
position to the upper position.
BT File size error The document is too large to print with Bluetooth. Data size is too big. Change or check the transmitted data.
BT Designation error The document is too complex to print with Bluetooth. Data quantity exceeded the range where it can be processed. Change or check the transmitted data.
BT structure error Data error. The document cannot be printed. There is an error in the contents of data. Change or check the transmitted data.
A part of the reference object
is broken (BT-MIME)
Data error. The document may not be printed correctly.
While XHTML-Print data could be decoded, a part or all of
the reference object had a MIME encode error and could not
be obtained. The following two problems are considered
depending on the type of the un-obtained reference object.
• For an image, an area where that image is to be printed
becomes blank.
• For a CSS (style sheet) file, the background color, basic
character size or the like cannot be the same as specified
by the send side.
Change or check the transmitted data.
BT communications error
Bluetooth print adapter not recognized. Please remove and
reinstall the adapter.
An error has occurred in communication with the BT
adapter.
Remove the BT adapter. Press the OK
button to clear the message.
To Next Page
Loading...
