Epson Stylus Photo RX585 - Page 49

EPSON Stylus Photo RX585/RX595/RX610 Revision B
Troubleshooting Troubleshooting When There is Error Display 49
Maintenance
error
A0H Waste ink overflow
Life expiration of maintenance
parts
 Replace all the maintenance parts, and clear the maintenance counter.
♦ Refer to “6.1.1 Maintenance Error” (p.116)
Abnormal
operation
88H Inserted tray error during cleaning
An error occurred during
cleaning
 Pulling out the CDR Tray
 Checking the CDR Tray Sensor (p.90)
♦Checking the CDR Tray Sensor for adhesion of dirt or dust
♦Checking the connection of the connector of the CDR Tray Sensor
 Checking the connection of the FFC
 Checking the following parts and replace the defective one:
♦CDR Tray Sensor (p.93)
♦CDR Tray
89H Overhit detection error during cleaning
 Checking the operation of the Carriage Assy;
Move the Carriage Assy by hand, and check to see if it moves smoothly.
 Checking the following parts and replacing the defective one:
♦Checking the lead wires of the CR Motor (CN14) for disconnection or breakage
♦Checking the CR Encoder FFC (CN1) for disconnection or breakage
♦Checking the printer frame for adhesion of dirt or insufficient lubrication (p.119)
♦Checking the CR Guide Shaft for adhesion of dirt or insufficient lubrication (p.119)
♦Checking the Linear Scale for adhesion of dirt or damage (p.75)
♦Checking the CR Encoder for adhesion of dirt or damage (p.90)
♦Checking the CR Belt for damage or improper tension (p.88)
♦Checking the CR Motor and replacing it if necessary (p.88)
♦Main Board (p.66)
Table 3-3. Fatal Errors (continued)
Category Error Code Error Cause Remedy