Epson Stylus Photo RX585 - 4.2.4 Waste Ink Tray Assy

EPSON Stylus Photo RX585/RX595/RX610 Revision B
Disassembly and Assembly Removal of Exterior Parts 69
4.2.4 Waste Ink Tray Assy
1. Remove the Panel Assy (p.63)
2. Remove the Scanner Unit (p.65)
3. Unlock the Carriage and move the Carriage Unit to the center of the printer.
(See 4.1.5 How to Unlock the Carriage (p.61))
4. Remove the screw and remove the EMI Frame. (Fig. 4-23)
5. Remove the screws (x2) that secure the Waste Ink Assy. (Fig. 4-23)
6. Disconnect the Waste Ink Tube from the Waste Ink Tray Assy, and remove the
Waste Ink Tray Assy. (Fig. 4-23)
Figure 4-23. Removing the Waste Ink Tray Assy
Figure 4-24. Notes on Installation of the Waste Ink Tray Assy
C A U T I O N
When removing the Waste Ink Tray Assy, take due care not to
stain any surrounding objects with waste ink.
When connecting the Waste Ink Tube, be careful of the following:
 Do not press the Waste Ink Tube when installing the Waste
Ink Tray Assy. Otherwise, the ink may leak.
 Route the tube with the red line facing up. (Fig. 4-24)
 Install the Waste Ink Tube with the tube passed through the
hook as shown in the figure. (Fig. 4-24)
 Wipe the ink, if any, off the joint area of the tube. With ink left
adhering to the joint area, the tube cannot be connected firmly
and may come off easily.
A D J U S T M E N T
R E Q U I R E D
On the occasion of replacing a part with a new one, replace all the
specified parts with new ones and clear the counter value after
assembly.
 5.2 Adjustment by Using Adjustment Program (p.101)
Bottom side
Waste Ink Tube
Bottom side
Waste Ink Assy
EMI Frame
C.B.P-TITE 3x6
Torque : 0.8±0.1N
·m
C.B.P-TITE 3x8 (x2)
Torque : 0.6±0.1N
·m
When installing the Waste Ink Tray
Assy, make sure the EJ Frame spring
is installed properly. (See p.91)
Install the EMI Frame under
the Main Board Shield Plate.
(See Fig. 4-16)
NG
NG
Do not pass the tube
through this hook
Do not lay the tube
over the rib
Rib
Route here
Lay the tube with red line facing up
Lay the tube
through this hook