Epson Stylus Photo RX585 - 4.5.2 I;S Assy

EPSON Stylus Photo RX585/RX595/RX610 Revision B
Disassembly and Assembly Disassembly and Assembly of Major Parts of Printer 84
4.5.2 I/S Assy
1. Remove the Printer Mechanism (p.76)
2. Remove the tube from the Waste Ink Assy (as required).
3. Remove the screws (x2), and remove the I/S Assy. (Fig. 4-59)
Figure 4-59. Removing the I/S Assy
Figure 4-60. Installing the I/S Assy
Figure 4-61. Installing the Waste Ink Tube (I/S Assy)
C A U T I O N
 Take due care not to stain any surrounding objects with ink. In
addition, when removing the Waste Ink Tube, take care not to
splash ink.
 Do not touch the head cleaner (wiper) with your bare hand, and
make sure that it is free from grease. Touching with your bare
hand or adhering grease can cause nozzle clogging.
 Lubrication is necessary. Refer to the following section and
lubricate the specified points:
LUBRICATION AT INSTALLATION OF I/S ASSY (p.120)

After installing the I/S Assy to the printer frame, make sure that
its position is adjusted as shown in
Fig. 4-60 .
 Tighten the screws in the specified order. (Fig. 4-59)

Catch the Waste Ink Tube in the groove shown in the figure on the
bottom of the I/S Assy.
(Fig. 4-61)
 When connecting the Waste Ink Tube, wipe the ink, if any, off
the joint area of the tube. With ink left adhering to the joint
area, the tube cannot be connected firmly and thus may easily
come off.
I/S Assy
1
C.B.S-TITE 3x6 (x2)
Torque : 0.8±0.1N
·m
2
Do not remove
Remove the
lower one
Waste Ink Tube
Catch it in here
~Bottom~