Epson Stylus Photo RX600 - Page 53

EPSON Stylus PHOTO RX600/610, RX620/630 Revision C
Disassembly and Assembly Disassembly and Assembly of Printer Unit 53
7. Remove the CR belt from the CR motor.
8. Remove a torsion spring from the carriage unit, and remove the carriage lever
from right side.
9. Unhook nine locations that secure the carriage unit to the head cable cover, and
remove the head cable cover.
10. Unhook two locations that secure holder I/C to the carriage, and shift the holder I/
C towards you.
11. Remove the carriage unit from the main frame upward.
Figure 4-11. Carriage Unit Removal-2
 Lubrication required. For lubrication, refer to the following
section.
6.3.3 Lubrication Points of the Printer (p83)
A D J U S T M E N T
R E Q U I R E D
After removing the carriage unit, make adjustments referring to
the following:
 Adjustment Items for Individual Units and Components (p65)
Carriage
Carriage Lever
Carriage Unit
Holder I/C
Torsion Spring
Head Cable Cover
Hook