Copying 17
3. Fan a stack of paper, and then tap it on a flat surface to even the
edges. Load the paper with the printable side facing down and
resting against the guide of the feeder guard.
4. Stand the stack of paper against the paper support and slide the left
edge guide so that it meets the left edge of the paper.
Note:
❏ Always load paper into the sheet feeder’s short edge first.
❏ Make sure that the paper stack is flush with or lower than the
triangular load-limit mark on the edge guide.
❏ Make sure that the paper is loaded under the tabs inside the edge
guides.
5. Set the feeder guard back.
guide
To Next Page
Loading...
