Epson Stylus Photo RX650 - 3.2.2 Warning List

EPSON Stylus PHOTO RX640/650 Revision A
Troubleshooting Troubleshooting When There is Error Display 23
3.2.2 Warning List
Table 3-2. Warning List
Causes Details Displayed Message (TBD) Recovery Procedure
In adjustment of borderless
expansion value
This message is always displayed during
adjustment of the Borderless Expansion Value.
You can change the amount of image enlargement.
If you reduce it too much, you may see a white border around your photo.
Guide Display “<OK>: Finish”
Press the OK button.
Position of CD/DVD guide
(Re-set)
Printer did not recognize the CD/DVD tray
correctly when it was about to start printing.
The front tray is in the wrong position.
Push down the tray lever to set the front tray to the CD/DVD position.
Pull down the lever to change the
print position to the lower position.
Set the CD/DVD guide
(Set correctly)
CD/DVD tray was not in its position when the
printer was about to stat printing,
The CD/DVD tray is set incorrectly.
Set the CD/DVD tray correctly, then press the Start button.
Guide Display “<Start Button>: Start”
Set the CD/DVD tray correctly, and
press the Start button.
Message related to ink (5) A non-genuine ink cartridge has been installed.
The installed ink cartridges listed below differ from the genuine Epson
ink cartridges for this printer.
[Y] [BK] [LC] [LM] [M] [C]
The use of other products may affect your print quality and could result in
printer damage.
Do you want to continue using the currently installed ink cartridges?
[Yes] [No]
Guide Display “<- ->:Make a Selection <OK>: OK”
Press the OK button
BT File size error The document is too large to print with Bluetooth.
Press the OK button or wait for a
certain time (approx. 5 seconds).
BT Designation error The document is too complex to print with Bluetooth.
Press the OK button or wait for a
certain time (approx. 5 seconds).
BT structure error
Error in the data.
The document cannot be printed.
Press the OK button or wait for a
certain time (approx. 5 seconds).
A part of the reference object
is broken (BT-MIME).
While XHTML-Print data could be decoded, a part
or all of the reference object had a MIME encode
error and could not be obtained.
The following two problems are considered
depending on the type of the un-obtained reference
object.
For an image, an area where that image is to be
printed becomes blank.
For a CSS (style sheet) file, the background color,
basic character size or the like cannot be specified
as intended at the send side.
Error in the data.
The document may not be printed correctly.
Press the OK button or wait for a
certain time (approx. 5 seconds).