Epson Stylus Photo RX650 - Page 24

EPSON Stylus PHOTO RX640/650 Revision A
Troubleshooting Troubleshooting When There is Error Display 24
A part of the reference object
cannot be buffered (BT-
MIME).
While XHTML-Print data could be decoded, a part
or all of reference object decoding was abandoned
due to memory shortage or excess of the max.
number of objects to be handled.
Error in the data.
The document may not be printed correctly.
Press the OK button or wait for a
certain time (approx. 5 seconds).
BT communications error
An error has occurred in communication with the
BT adapter.
Bluetooth print adapter cannot be recognized.
Please remove and reinstall the adapter.
Guide Display “<OK>: Cancel”
Remove the BT adapter.
Press the OK button to delete the
message.
External device installment An unsupported device has been installed.
Cannot recognize the USB device.
Guide Display “<OK>: Finish”
Press the OK button
Menu change or printing
operation with a DSC
connected
Entering a menu screen for use of memory cards or
starting to print was attempted with a DSC
connected.
Camera is connected.
Disconnect the camera and try again.
Guide Display “<OK>: Cancel”
Press the OK button
Reprint/Restore Photos Cannot recognize the Photos
No photos could be recognized. Make sure the photos are positioned
correctly. For details, see your manual.
Guide Display “<OK>: Finish”
Press the OK button
Film print Cannot recognize the Film
A slide or negative could not be recognized.
Make sure the film holder is properly positioned and the film is inserted
in the holder.
For details, see your manual.
Guide Display “<OK>: Finish”
Press the OK button
Combo print error 1 (Euro)
Photo Greeting card error 1
(EAI)
No recognition mark could be found on the
template sheet.
There was an error reading the template.
Check that the template is correctly located on the glass and try again.
Guide Display “<OK>: Finish”
Press the OK button
Combo print error 2 (Euro)
No mark is given in the Paper Type or Text Style
selection area, or more than one mark is given.
Selection of the text style is not correct.
Please select only one text style and try again.
Guide Display “<OK>: Finish”
Press the OK button
Photo Greeting card error 3
(EAI)
No mark is given for compose layout, or more than
one mark is given.
The layout has not been selected or the ovals are not marked correctly.
Only one layout may be selected.
Please correct and try again.
Guide Display “<OK>: Finish”
Press the OK button
Photo Greeting card error 4
(EAI)
No mark is given for compose paper type, or more
than one mark is given.
The paper type has not been selected or the ovals are not marked
correctly.
Only one paper type may be selected.
Please correct and try again.
Guide Display “<OK>: Finish”
Press the OK button
Table 3-2. Warning List (continued)
Causes Details Displayed Message (TBD) Recovery Procedure