Epson Stylus Photo RX650 - 4.2 Removal of Exterior Parts; 4.2.1 Panel Assy

EPSON Stylus PHOTO RX640/650 Revision A
Disassembly and Assembly Removal of Exterior Parts 43
4.2 Removal of Exterior Parts
4.2.1 Panel Assy
1. Open the Scanner Unit, and remove the screws (x3) securing the Middle Cover
Assy. (Fig. 4-1)
2. Release the hooks (x3 at points marked with ∆) on the Printer Mechanism, the
hooks (x5) in the front and the hook at the right side, and remove the Middle Cover
Assy.
3. Release the hooks at the right and left ends from the direction of the back of the
panel, raise the decorative panel, release all the hooks carefully and remove the
decorative panel. (Fig. 4-2)
4. Remove the screws (x2) securing the Panel Assy. (Fig. 4-3)
5. Lift the Panel Assy, and disconnect the FFCs (x2).
Figure 4-1. Removing the Middle Cover Assy
Figure 4-2. Removing the Decorative Panel
Figure 4-3. Removing the Panel Unit
Figure 4-4. Notes on Installing the Panel Assy
 Install the decorative panel, taking care not to confuse the
front and back of the Light Conduction Tubes. (Fig. 4-4)
 When installing the Middle Cover, take care not to catch the
Head FFC. If possible, move the carriage to the left
beforehand. (Fig. 4-4)
Hook(x3)
Hook (x5)
C.B.P-TITE 3x10 (x3)
Torque : 0.6±0.1N
·m
Hook (x10)
C.B.P-TITE 3x8 (x2)
Torque : 0.6±0.1N
·m
Light Conduction
Tubes
CN15
Disconnect
Install it in front of
the Head FFC
Position the thinner
tip upward
Align
Light Conduction Tubes
Middle Cover