Epson Stylus Photo RX650 - Disassembly of TPU Unit

EPSON Stylus PHOTO RX640/650 Revision A
Disassembly and Assembly Disassembly of Scanner Unit 59
4.4.5 Disassembly of TPU Unit
1. Remove the Scanner Unit (p.45)
2. Remove the TPU Unit while pushing the hook (middle) in the hinge area of the
TPU Unit. (Fig. 4-46)
3. Remove the screws (x4) securing the TPU Cover. (Fig. 4-47)
4. Lift the threaded hole side of the Harness Cover slightly, and remove the cover by
sliding it toward the front.
5. Remove the Film Holder.
6. Release the right and left hooks (3x2), and remove the TPU Cover.
(éüÇÃÉyÅ[ÉWÇ÷ë±Ç¦)
Figure 4-46. Removing the TPU Unit
Figure 4-47. Removing the TPU Cover
 When installing the TPU Cover, engage the hooks (x4) in the
front first and then engage the right and left hooks (x3).
 When installing the Harness Cover, insert the Harness Clamp
area in the position shown below first and then slide the cover
from the front side into its position.

Harness Cover
Hinge area
Hook
Hooks
Harness Cover
Lift it slightly and pull it
toward you
2 13 4
C.B.P-TITE 2.5x10 (x4)
Torque : 0.6±0.1N
·m