Epson Stylus Photo RX650 - I;S Assy

EPSON Stylus PHOTO RX640/650 Revision A
Disassembly and Assembly Disassembly and Assembly of Major Parts of Printer 62
4.5.2 I/S Assy
1. Remove the Printer Mechanism (p.53)
2. Remove the tube from the Waste Ink Assy (as required).
3. Remove the screws (x2), and remove the I/S Assy. (Fig. 4-54)
Figure 4-54. Removing the I/S Assy
Figure 4-55. Installing the I/S Assy
Figure 4-56. Installing the Waste Ink Tube (I/S Assy)
C A U T I O N
Take due care not to stain any surrounding objects with ink.
In addition, when removing the Waste Ink Tube, take care not to
splash ink.
 Lubrication is necessary. Refer to the following section and
lubricate the specified points:
Lubrication at Installation of I/S Assy (p.81)
 After installing the I/S Assy to the printer frame, make sure
that its position is adjusted as shown in Fig.4-55 .
 Tighten the screws in the specified order. (Fig. 4-54)
 Catch the Waste Ink Tube in the groove shown in the figure on
the bottom of the I/S Assy. (Fig. 4-56)
 When connecting the Waste Ink Tube, wipe the ink, if any, off
the joint area of the tube. With ink left adhering to the joint
area, the tube cannot be connected firmly and thus may easily
come off.
I/S Assy
1
2
Do not remove
Remove the
lower one
C.B.S-TITE 3x6 (x2)
Torque : 0.8±0.1N
·m
Waste Ink Tube
Catch it in here
~Bottom~