Epson Stylus Photo RX700 - Ink System Assy

EPSON Stylus Photo RX900 Revision A
Disassembly and Assembly Disassembly and Assembly of Major Parts of Printer 112
4.4.8 Ink System Assy
1. Remove the Printer Mechanism. (p.107)
2. Remove the screws (x2) securing the Ink System Assy at the right side of the printer.
3. Release the projections from the printer frame, and remove the Ink System Assy.
Figure 4-47. Removing the Ink System Assy
Figure 4-48. Installing the Ink System Assy
C A U T I O N
The print quality may be degraded if skin grease adheres to the
wiper. Do not touch the wiper with your bare hand.
C H E C K
P O I N T
For easy work, you are advised to move the carriage from the
home position before disassembling the Stylus Photo RX700.
(Move the carriage by turning power ON and then turning it OFF
timely.)
 Before tightening the screw, check that the projections (x3) are
located as shown at right.
 Confirm that the ground spring is located as shown at right.
(See Figure 4-48)
Ink System Assy
Torque: 0.6 ± 0.1N
⋅m
C.B.P-Tite 3x8 F/ZN-3C
Torque: 0.8 ± 0.1N
⋅m
C.B.S-Tite 3x6 F/ZN-3C
Projection
Projection
Hook
Ground spring