Epson Stylus Photo RX700 - CR Motor

EPSON Stylus Photo RX900 Revision A
Disassembly and Assembly Disassembly and Assembly of Major Parts of Printer 115
4.4.11 CR Motor
1. Remove the Printer Mechanism. (p.107)
2. Remove the tension spring of the Driven Pulley Assy at the rear of the printer.
3. Remove the two screws, and remove the CR Motor from the printer frame.
Figure 4-52. Removing the CR Motor
Lubrication is necessary. Refer to the following section and
lubricate the specified points:
 Lubrication of Driven Pulley Assy (p.154)
A D J U S T M E N T
R E Q U I R E D
Once the CR Motor has been replaced with a new one, refer to the
following section and perform the necessary adjustments.
 5.1.1 Adjustment Items (p.134)
Driven Pulley Assy
CR Belt
CR Motor
Driven Pulley Assy
Tension spring
Torque: 0.x ± 0.xN
⋅m
Screws (x2)