Epson Stylus Photo RX700 - 5.4 Scanner Home Position Adjustment

EPSON Stylus Photo RX700 Revision B
Adjustment Scanner Home Position Adjustment 142
RevisionB
5.4 Scanner Home Position Adjustment
5.4.1 Overview
The home position of the Scanner Unit deviates when the CCD Unit, Scanner CR
Motor Assy or any other scanner carriage-related component has been replaced or
reinstalled. Make this adjustment to enhance scanning accuracy.
Note : “{”: available on the market, “EPSON”: available from EPSON
Note “*”: With Win2000, the USB driver must be reinstalled after several times of USB
connection. Therefore, use of a PC with Win2000 is not recommend.
5.4.2 Preparations for Use of the Adjustment Program
1. Execute the supplied file (C583B02W.exe), and install the adjustment program onto
the PC.
NOTE: This program is a self-extracting installer. Upon execution, the window
(shown at right) appears. Designate the place where the program is to be
installed. If you check the check box “Make Start Menu for ...” at this point,
this adjustment program will be registered in the start menu.
2. Start the adjustment program by one of the following methods:
 “Start Menu” → “Program for Production” → “C583B02W”
 Execute “FT.exe” in the folder that has been installed as described above.
Figure 5-13. Installing the Adjustment Program (Scanner Home Position)
Table 5-6. Tools
Tool Name Availability Tool Code
PC (OS: Windows 98/XP)*
{
–
Adjustment Program
• EPSON Scanner Function Test-C583B02W
EPSON
USB cable (Printer ~PC)
{
–
Origin adjustment tool EPSON 1401646
C H E C K
P O I N T
This adjustment program has not only the home position
adjustment function but also other various functions. However,
this manual describes only the functions and procedure necessary
for home position adjustment.
C H E C K
P O I N T
The scanner driver must have been installed on the PC (scanner
must be recognized). If the PC does not recognize the scanner, the
following error window will appear at the start of adjustment.
Check this box to
register the program
in the start menu
Designate the place where the program is to be installed.
(Default : C:¥Program for Production¥C583B02W)