Epson Stylus Photo RX700 - Page 156

EPSON Stylus Photo RX700 Revision A
Maintenance Lubrication 156
 Lubrication of Carriage Assy
Figure 6-9. Lubrication of the Carriage Assy 1
Figure 6-10. Lubrication of the Carriage Assy 2
Figure 6-11. Lubrication of the CR Guide Shafts
Figure 6-12. Lubrication of the CR Scale Mounting Plate Assy
Table 6-13. Lubrication of Carriage Assy
Assy to be
Lubricated
(Reference Page)
Lubrication Points/Amount of Application Type
Precautions
(Fig No.)
PG Cam Bush
(p.116)
 Lubrication Points: Periphery (x4)
 Amount of Application: ø1x1mm (Use an injector)
G-26
Figure 6-9
 Lubrication Points: Bore surface (x4)
 Amount of Application: ø1x1mm (Use an injector)
G-26
Printer Frame
 Lubrication Points: CR Guide Shaft support surface (x4)
 Amount of Application: (Apply with a brush)
G-26
CR Left Scale
Plate
 Lubrication Points: Shaft support surface and sliding surface
 Amount of Application: ø1x5mm (Use an injector)
G-26
Figure
6-10
 Lubrication Points: Frame sliding surface
 Amount of Application: ø1x2mm (Use an injector)
G-26
CR Guide Shafts
(spring support
area)
 Lubrication Points: Spring support area at left end of CR
Guide Shafts (x2)
 Amount of Application: ø1xXmm (Use an injector)
G-26
CR Guide Shafts
 Lubrication Points: Carriage Assy sliding surface (x2)
 Amount of Application:
G-71
Figure
6-11
CR Scale
Mounting Plate
Assy (p.116)
 Lubrication Points: Back side sliding surface (x6)
 Amount of Application: ø1xXmm (Use an injector)
G-26
Figure
6-12
 Lubrication Points: Shaft support surface (x2)
 Amount of Application: ø1xXmm (Use an injector)
G-26
 Lubrication Points: Gear mounting shafts (x3)
 Amount of Application: ø1x2mm (Use an injector)
G-26
Periphery
Bore
Bore
Periphery
Shaft support
surface
Shaft support
surface