EPSON Stylus Photo RX900 Revision A
Disassembly and Assembly Removal of Exterior Parts 89
(Continued to next page)
Figure 4-14. Connection of the Waste Ink Tubes
Figure 4-15. Checking the TPU Harness
Figure 4-16. Placing of Relay Connectors
Figure 4-17. Clearance around the Posts on the Middle Housing
Before installing the Middle Housing, check the following
conditions for properness:
• Connection of each Waste Ink Tube (x2) (See Figure 4-14)
• Connector orientation and routing of TPU Harness
(See Figure 4-15)
• Clearance around each post on the rear of the Middle
Housing (x2) (See Figure 4-17)
• Placing of Relay Connectors (See Figure 4-16)
• Use of Harness Clamp and fastening of lead wires
(See Figure 4-16)
• Installation of Linear Scale
Waste Ink Tube (Blue)
Waste Ink Tube (Red)
Confirm the orientation of the
connector of the TPU Harness
TPU Harness
Lead it out through here
Push the Relay Connectors adequately
so that they will not rise.
Harness Clamp
To Next Page
Loading...
