EPSON Stylus Photo RX900 Revision A
Disassembly and Assembly Removal of Exterior Parts 90
Figure 4-18. Routing of Lead Wires and FFCs
When installing the Middle Housing, lead out the connectors
and FFCs through the respective areas shown below in the
Middle Housing.
White (Power Supply Connector)
FFC (Right I/C Holder)
White (I/C Cover Sensor Connector)
Yellow (Tray Cover Sensor Connector)Red (Tray Cover Sensor Connector)
FFCx4 (Head FFC)
FFC (CR Encoder Board)
Black (CD-R Sensor 1 Connector)
FFC (Left I/C Holder)
White (Relay Connector)
Yellow (PE Sensor Assy Connector)
Blue (CD-R Sensor 2 Connector)
White (APG Sensor Connector)
White (TPU Harness Connector)
FFC (PF Encoder)
Install the ferrite core for the
CR Encoder FFC (CN3)
Route the lead wires of the following
connectors under this hook:
• Yellow (PE Sensor Assy Connector)
• Blue (CD-R Sensor 2 Connector)
• White (APG Sensor Connector)
• Black (CD-R Sensor 1 Connector)
To Next Page
Loading...
