Epson Stylus Photo TX730WD - Page 127

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD Revision G
DISASSEMBLY/ASSEMBLY Disassembly Procedures 127
Confidential
Figure 4-41. Connector position on the Main Board
2. Remove the screw (x1) that secures the Right Cable Frame and the Main
Board. (See
Fig. 4-42.)
3. Remove the screw (x1) that secures the Grounding Plate M/B, and remove the
Grounding Plate M/B. (See
Fig. 4-42.)
4. Remove the screws (x4) that secure the Main Board Unit and remove the
Main Board Unit.
Figure 4-42. Removing the Main Board Unit
CN501
CN22 CN24 CN25 CN41 CN10
CN51
CN12
CN9 CN33
CN6 CN4 CN3 CN2
CN1
CN36
CN5
CN31
CN7
CN49CN21
CN13
CN8
CN19
C.B.P. 3x10 (6±1Kgfcm)
Holder IC Shield Plate
C.B.P. 3x8 (6±1Kgfcm)C.B.S. 3x6 (8±1Kgfcm)
C.B.S. 3x6 (6±1Kgfcm)
C.B.S. 3x4 (8±1Kgfcm) C.B.S. 3x6 (5±0.5Kgfcm)
Step 2
Step 3
Positioning hole & dowel
Right Cable Frame
Main Board Unit
Grounding Plate M/B